Teach you to distinguish between the quality of LED display screen

Source: Rimage Time: 2017-02-15 Reading: 382

A piece of LED display quality is good or bad, for the average user is not completely clear understanding, Ming Hing optical teach you to identify a number of full color display quality is good or bad way, hope that customers in the purchase of LED full color display Helpful.

A good or bad LED display can be signed from the following aspects:

Smoothness

The surface roughness of the display should be within ± 1mm to ensure that the displayed image does not distort, and the local bulge or recess will cause the viewing angle of the display to appear dead. The flatness is determined by the production process.

2. Brightness and visual angle

Indoor full color of the brightness to 800cd / m2 or more, outdoor full color brightness to 1500cd / m2 or more, in order to ensure the normal work of the display, otherwise because the brightness is too low to see the displayed image. The brightness of the size of the LED die is mainly determined by the good or bad. The size of the viewing angle directly determines the number of display screen audience, so the bigger the better. The viewing angle is mainly determined by the way the die is encapsulated.

3. White balance effect

White balance effect is one of the most important indicators of the display. Color when the red, green and blue primary colors ratio of 1: 4.6: 0.16 will show a pure white, if the actual proportion of a slight deviation will appear white balance deviation, generally pay attention to whether the white blue, yellow Green phenomenon. White balance is mainly determined by the control system to determine the screen, the color of the reductive also affected.

4. The reduction of color

Color reduction is the display of the color of the reduction, both the display screen to play with the color of the source to maintain a high degree of consistency, so as to ensure the image of the realism.

5. whether the mosaic, dead phenomenon

Mosaic refers to the display appears on the bright or often black small squares, both module necrosis, the main reason for the display screen used by the quality of the connector, but off. Dead point is the display screen appears on the bright or often black single point, the number of dead spots mainly by the die is good or bad to decide.

6. No color blocks

Color block refers to the adjacent module between the obvious color difference, the color of the transition to the module as a unit, causing color phenomenon is mainly due to poor control system, gray level is not high, the scanning frequency caused by low.


Share it: